LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Transfer Case - Mp 3023/3024-NQH) >> Diagnostic Information and Procedures >> Transfer Case High/Low Clutch Reset >> Using a Scan Tool

Using a Scan Tool

WARNING: This page is about a different variant/trim than selected.
  1. Key ON, engine OFF.
  2. Select the Module Setup heading on the scan tool, under transfer case control module.
  3. Select the Range Actuator Learn procedure.
  4. When the Range Actuator Learn procedure is initiated you should hear the motor engage, indicating a successful learn procedure.
scientia non olet · About LEMON Manuals