LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Bracket & Bolt
    GM1964900Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP canister (2) to the bracket (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the EVAP canister bolt (1).

    Tighten 

    Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of EVAP Canister Assembly & Bolts
    GM1964898Courtesy of GENERAL MOTORS COMPANY
  3. Position and install the EVAP canister assembly (2) to the fame bracket tab.
  4. Install the EVAP canister bolts (1).

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 3: Locating Quick Connect Fittings
    GM1964897Courtesy of GENERAL MOTORS COMPANY
  5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals