LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Auxiliary Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Auxiliary EVAP Canister
    GM1965658Courtesy of GENERAL MOTORS COMPANY
  1. Install the auxiliary EVAP canister (1) to the vehicle.
    2. Fig 2: View Of Auxiliary EVAP Canister Nuts
    GM1965655Courtesy of GENERAL MOTORS COMPANY
  2. Install the auxiliary EVAP canister nuts (1).
    3. Fig 3: Locating Quick Connect Fittings
    GM1964762Courtesy of GENERAL MOTORS COMPANY
  3. Connect the EVAP pipe quick connect fitting (3) to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the EVAP canister vent solenoid valve. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .
scientia non olet · About LEMON Manuals