LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2023 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Rear Output Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Cadillac Escalade EXT, 2013 Cadillac Escalade ESV, and 2013 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Rear Output Shaft Seal With Flathead Screwdriver
    GM1728918Courtesy of GENERAL MOTORS COMPANY
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  4. Remove the rear output shaft seal by prying it out with a flat-bladed tool.
scientia non olet · About LEMON Manuals