LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2023 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Cadillac Escalade EXT, 2013 Cadillac Escalade ESV, and 2013 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seal Installation Special Tools
    GM1728904Courtesy of GENERAL MOTORS COMPANY
  1. Install the J 43484  installer (2) to the GE-8092  handle (1).
  2. Install a NEW seal onto J 43484  installer.
  3. Using J 43484  installer (2), and GE-8092  handle (1), install the seal.
  4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  5. Check the fluid level. Add fluid, if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals