Poor Fuel Fill Quality

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Suburban, 2013 Chevrolet Avalanche, and 2013 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Problem	Causes
DEFINITION: During the fueling process a continual, occasional, or no-fuel nozzle shut-off condition has occurred.
Difficult to fill	Fuel fill limiter vent valve stuck closed Evaporative emission (EVAP) canister restricted EVAP vent valve stuck closed Hose between canister and canister vent solenoid twisted or kinked if applicable High fuel temperature Fuel filler hose is kinked Faulty dispensing nozzle Ignition switch ON, vent valve closed
Over fill	Fill limiter vent valve stuck open or leaking Fuel inlet check valve stuck open
Pre-mature shut-off of the fuel dispensing nozzle occurs immediately after engaging dispensing nozzle, tank empty	Restricted vapor lines or fuel fill pipe High fuel temperature Inlet check valve at tank stuck closed, fill pipe full of fuel Fuel tank full, gauge not accurate
Pre-mature shut-off of the fuel dispensing nozzle, more than 1/8 of tank capacity dispensed	Kinked, pinched or plugged lines in fuel tank vent system EVAP vent valve stuck closed or restricted EVAP canister restricted Fuel limiting vent valve stuck closed or obstruction at top of fuel tank
Fuel Spitback	Restricted EVAP canister High fuel temperature Ignition switch ON, EVAP vent valve closed