Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Suburban, 2013 Chevrolet Avalanche, and 2013 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Ignition ON, observe the scan tool DTC information. Verify there are no other DTCs set.
- If a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
Engine idling, observe the MAP sensor parameter. The reading should be between 19-42 kPa (2.7-6 PSI).
- If not within the specified range, refer to DTC P0106 , or DTC P0107 or P0108 .
Ignition OFF, verify that none of the conditions listed below exists:
- Inspect the air induction system for modified, damaged, leaking, or restricted components.
- Inspect the crankcase ventilation system for improper operation. Refer to Crankcase Ventilation System Inspection/Diagnosis .
- Inspect the vacuum hoses for splits, kinks, and improper connections.
- Test for a restricted, damaged, leaking, or modified exhaust system from the catalytic converter forward. Refer to Symptoms - Engine Exhaust .
- Inspect for vacuum leaks at the intake manifold, the throttle body, and the injector O-rings.
- Test the fuel injectors for improper operation. Refer to Fuel Injector Diagnosis (CH47976) , Fuel Injector Diagnosis (J39021 or Scan Tool) .
- Test for fuel contamination. Refer to Alcohol/Contaminants-in-Fuel Diagnosis .
- Test for excessive fuel in the crankcase due to leaking injectors.
- Test the ignition system for improper operation. Refer to Electronic Ignition System Diagnosis .
If all the above conditions test normal, test the engine for any mechanical conditions which could alter the flow into the combustion chamber. Refer to Symptoms - Engine Mechanical .