LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2022 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0442 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Alcohol/Contaminants-in-Fuel Diagnosis >> Particulate Contaminants in Fuel Testing Procedure

Particulate Contaminants in Fuel Testing Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Suburban, 2013 Chevrolet Avalanche, and 2013 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel.
  2. Place the container on a level surface for approximately 5 minutes in order to allow settling of the particulate contamination. Particulate contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as black and irregular particles.
  3. Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system.
scientia non olet · About LEMON Manuals