LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls/Fuel - 1.8L (LUW, LWE) - DTC P0443 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0641, P0651, P0697, or P06A3 (ECM) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:

Additional DTCs will set when disconnecting the components.

  1. Ignition OFF, disconnect the harness connector at all appropriate sensors for the applicable DTC. Refer to Diagnostic Aids .
  2. Ignition ON.
  3. Test for 4.8-5.2 V between one of the 5 V reference circuits and ground.
    • If less than 4.8 V 
    1. Ignition OFF, disconnect the harness connectors at the K20 Engine Control Module.
    2. Test for infinite resistance between the 5 V reference circuit for each applicable component and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K20 Engine Control Module.
    • If greater than 5.2 V 
    1. Ignition OFF, disconnect the harness connectors at the K20 Engine Control Module.
    2. Test for less than 1 V between the 5 V reference circuit for each applicable component and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K20 Engine Control Module.
    • If between 4.8-5.2 V 
    4. NOTE:

    A short to voltage or ground on the signal circuit of certain components may cause this DTC to set.

  4. Verify the appropriate scan tool 5 V Reference 1, 2, 3, or 4 Circuit Status parameter displays OK while connecting each component associated with the 5 V reference circuit one at a time.
    • If the parameter does not display OK when a component is connected 

      Replace the component

scientia non olet · About LEMON Manuals