Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, clear the DTC information with a scan tool. Observe the DTC information with a scan tool.
- Verify that DTC P0641, P0651, P0697, or P06A3 does not set.
- If a DTC is set
Refer to DTC P0641, P0651, P0697, or P06A3 (ECM) for further diagnosis.
- If DTC P0641, P0651, P0697, or P06A3 does not set
- If a DTC is set
- Observe the DTC information with a scan tool. Verify DTC P0602 or P0630 is not set.
- If DTC P0602 or P0630 is set
- Program the K20 Engine Control Module. Refer to Control Module References .
- Verify DTC P0602 or P0630 is not set.
- If DTC P0602 or P0630 sets, replace the K20 Engine Control Module.
- If DTC P0602 or P0630 does not set
- All OK.
- If DTC P0602 or P0630 is not set
- Verify DTC P0601, P0603, P0604, P0606, P062F, P16F3, or P262B is not set.
- If DTC P0601, P0603, P0604, P0606, P062F, P16F3, or P262B is set
Replace the K20 Engine Control Module.
- If DTC P0601, P0603, P0604, P0606, P062F, P16F3, or P262B is not set
- If DTC P0601, P0603, P0604, P0606, P062F, P16F3, or P262B is set
- All OK.