Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON, engine OFF,
Command the EVAP Vent Solenoid Valve ON - Not Venting and OFF - Venting with a scan tool.
You should hear the solenoid click when commanded ON and OFF.
- No clicking heard
  Refer to Circuit/System Testing
- Clicking is heard
Engine idling, command the EVAP Vent Solenoid Valve ON - Not Venting and OFF - Venting with a scan tool while observing the following control circuit status parameters:
- EVAP Vent Solenoid Valve Control Circuit Low Voltage Test Status
- EVAP Vent Solenoid Valve Control Circuit Open Test Status
- EVAP Vent Solenoid Valve Control Circuit High Voltage Test Status
- If the Parameters display Malfunction
  Refer to Circuit/System Testing
- If the Parameters display OK or Not Run
Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.