Cooler Flow Check and Flushing Steps
WARNING: This page is about a different variant/trim than selected.
- Machine Set-up
- Determine Minimum Flow Rate
- Back Flush
- Forward Flush
- Flow Test
- Code Recording Procedure
- Clean-up
Special Tools
- DT-45096 Transmission Oil Cooling System Flush and Flow Test Tool
- DT-45096-50 Transmission Cooler Flush Adapter
- Shop air supply with water/oil filters, regulator and pressure gauge - minimum 90 psi
- Eye protection
- Rubber gloves
For equivalent regional tools, refer to Special Tools .