Conditions for Running the DTC

P2714

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
• High side driver is enabled.
• Throttle position signal is valid.
• Ignition voltage is between 9-32 V.
• Transmission fluid temperature is -7°C (19°F) or greater.
• Engine speed is between 400-7500 RPM for 5 seconds.
• 2-6 clutch is commanded ON.
• Output speed is 650 RPM or greater, or the throttle position is greater than 0.5 percent.

P2715

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
• Ignition voltage is between 9-32 V.
• Transmission output shaft speed is 200 RPM or greater.
• Engine speed is between 400-7500 RPM for 5 seconds.
• 2-6 clutch is commanded OFF.
• Transmission fluid temperature is 0°C (32°F) or greater.
• Attained range is not 1st gear.
• High side driver is enabled.
• Transmission input speed is 200 RPM or greater.