Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, remove the Q8 control solenoid valve assembly, filter plate, channel plate and spacer plate. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement , and Control Valve Body Replacement .
- Inspect the Q8 control solenoid valve assembly, filter plate, channel plate, and spacer plate for debris and blocked orifices.
NOTE:
You must perform the Circuit/System Verification first.
- If debris or blocked orifices are observed
Clean or replace as necessary.
- If no debris or blocked orifices are observed
Replace the Q8 control solenoid valve assembly.