Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0815 - Condition 1
Transmission control module (TCM) detects an upshift request for 1 second with the shift lever in PARK, or NEUTRAL.
P0815 - Condition 2
TCM detects an upshift request for 10 minutes with the shift lever in a forward range.
P0816 - Condition 1
TCM detects a downshift request for 1 second with the shift lever in PARK, or NEUTRAL.
P0816 - Condition 2
TCM detects a downshift request for 10 minutes with the shift lever in a forward range.
P0826
TCM detects an invalid voltage on the TAP up/down signal circuit for 1 minute.