Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0776
The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 3-5-R clutch is commanded ON for 4 seconds and the transmission input shaft speed is 400 RPM or greater from the anticipated input shaft speed. This must occur 3 times.
P0777
The TCM detects an incorrect off-going clutch gear ratio, or tie-up, when the 3-5-R clutch is commanded OFF for 1 second and the transmission input shaft speed is 400 RPM or less from the anticipated input shaft speed. This must occur 3 times.