Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0776

DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
Engine speed is between 400-7500 RPM for 5 seconds.
Ignition voltage is between 9-32 V.
Transmission fluid temperature is -7°C (19°F) or greater.
Transmission output speed is 650 RPM or greater, or the throttle position is 0.5 percent or greater.
Throttle position signal is valid.
High side driver is enabled.

P0777

DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
Engine speed is between 400-7500 RPM for 5 seconds.
Ignition voltage is between 9-32 V.
Transmission fluid temperature is -7°C (19°F) or greater.
Transmission output shaft speed is 200 RPM or greater.
Throttle position signal is valid.
High side driver is enabled.