Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Application	Specification
Application	Metric	English
5th Speed Connecting Claw Support Bolts	9 N.m	80 lb in
5th Speed Fork Bolts	22 N.m	16 lb ft
5th Speed Fork Support Bolts	22 N.m	16 lb ft
Adjusting Sleeve Retaining Plate Bolt	9 N.m	80 lb in
Backup Lamp Switch	40 N.m	30 lb ft
Bar Bolts at Control Arm Pivot Area	100 N.m	74 lb ft
Bearing Cover and Retaining Plate Bolts - M8	20 N.m	15 lb ft
Brake Booster Hose Connection at Intake Manifold	18 N.m	13 lb ft
Clutch Bearing Guide-to-Transmission Bolts	5 N.m	44 lb in
Clutch Cover Bolts	15 N.m	11 lb ft
Clutch Fork Bolt	35 N.m	26 lb ft
Clutch Housing Cover Bolts	6 N.m	53 lb in
Clutch Housing Cover Plate Bolts	6 N.m	53 lb in
Clutch Line Bracket Bolts	25 N.m	18 lb ft
Clutch Release Cylinder Bolts	12 N.m	106 lb in
Compressor Bolts	45.5 N.m	34 lb ft
Connecting Bridge Bolts	7 N.m	62 lb in
Control Lever Housing Bolts	12 N.m	106 lb in
Coupling Clamp Bolt	31.5 N.m	23 lb ft
Damping Weight-to-Linkage Bolt	20 N.m	15 lb ft
Differential Case Bearing Adjusting Sleeve Lock Bolt	9 N.m	80 lb in
Differential Cover-to-Transmission Bolts
Light Alloy Version	18 N.m	13 lb ft
Sheet Metal Version	30 N.m	22 lb ft
Differential Cover Bolts	7 N.m	62 lb in
Drain Plug	39 N.m	29 lb ft
Engine Mount and Rear Engine Mount Bracket Bolts	67.5 N.m	50 lb ft
Engine Rear Bracket-to-Engine Mount Bolt	62.5 N.m	46 lb ft
Fill Plug	39 N.m	29 lb ft
Front Shift Lever Ball Stud Retainer	12.5 N.m	111 lb in
Front Suspension Steering Knuckle Pivot - Ball Joint, Bolt	31.5 N.m	23 lb ft
Front Suspension Tension Bar Nut	90 N.m	66 lb ft
Front Transmission Mount Bolts	68 N.m	50 lb ft
Guide Bolts	5 N.m	44 lb in
Ground Cable Bolts	13 N.m	115 lb in
Inspection Plug	4 N.m+ 45° + 90°	35 lb in + 45° + 90°
Left Engine Bracket Bolts - All	62.5 N.m	46 lb ft
Left Engine Mount Bracket and Engine Mount Bolts	67.5 N.m	50 lb ft
Left Transaxle Mount Bracket Bolts	52 N.m	38 lb ft
Left Transaxle Mount Bolts	52 N.m	38 lb ft
Left Transaxle Mount Through Bolt	80 N.m	59 lb ft
Linkage Clamp-to-Shift Control Guide Bolt	26.5 N.m	20 lb ft
Linkage-to-Shift Control Guide Coupling Clamp Bolt	31.5 N.m	23 lb ft
Lock Ball Assembly	29 N.m	22 lb ft
Lock Pin Bridge Bolts	7 N.m	62 lb in
Lower Transmission to Engine Bolts
#1 Bolts	64 N.m	47 lb ft
#2 Bolts	47 N.m	35 lb ft
#3 Bolts	23 N.m	17 lb ft
Output Speed Sensor	24 N.m	18 lb ft
Pedal Shaft Nut	20 N.m	15 lb ft
Pedal Support-to-Dash Panel Nut	20 N.m	15 lb ft
Pedal Support with Brake Booster Support-to-Dash Panel Nuts	20 N.m	15 lb ft
Pivot-to-Steering Knuckle Bolt	31.5 N.m	23 lb ft
Rear Transmission Mount Bolts	68 N.m	50 lb ft
Retaining Plate Bolts	22 N.m	16 lb ft
Retaining Plate Cover Bolts - M7	15 N.m	11 lb ft
Reverse/Backup Lamp Switch	20 N.m	15 lb ft
Reverse Lamp Switch at Transmission	20 N.m	15 lb ft
Right Engine Mount-to-Engine Bracket Bolt and Nut	62.5 N.m	46 lb ft
Ring Gear Bolts	90 N.m	66 lb ft
Shift Control Cover-to-Transmission Bolts	15 N.m	11 lb ft
Shift Lever Bracket-to-Floor Panel Tunnel Bolt	6 N.m	53 lb in
Shift Lever Shaft Assembly	19 N.m	14 lb ft
Speedometer Sensor Bolt	5 N.m	44 lb in
Starter Wire Nut	10 N.m	87 lb in
Starter Motor Retaining Bolts	37 N.m	28 lb ft
Tension Bar Bolts-to-Front Suspension Control Arm	100 N.m	74 lb ft
Tie Rod End Nuts-to-Front Suspension Steering Knuckle	34 N.m	25 lb ft
Transmission Bolts - Plate	22 N.m	16 lb ft
Transmission Bracket Bolts	72.5 N.m	53 lb ft
Transmission Cover Bolts - Short	8 N.m	71 lb in
Transmission Cover Bolts - Long	24 N.m	18 lb ft
Transmission-to-Engine Bolts - All	70 N.m	52 lb ft
Wheel Bolts	110 N.m	81 lb ft