Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Transmission Rear Mount Bracket Through Bolt

GM2503662

Courtesy of GENERAL MOTORS COMPANY

Push and hold the powertrain assembly forward and then install the transmission mount (3), if necessary.

CAUTION:

Refer to Fastener Caution .

Install the transmission rear mount fastener (2) and tighten to 100 (74 lb ft).
Install the NEW transmission mount to bracket through fastener (1) and tighten to 80 (59 lb ft) plus 45-60 degrees.
Remove the jack stand.
Lower the vehicle.