Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the transmission rear mount bracket (2).
- Install the NEW transmission mount bracket bolts (1) and tighten to 100 N.m (74 lb ft) plus 30-45 degrees.
- Install the NEW transmission mount to bracket through bolt (1) and tighten nut to 80 N.m (59 lb ft) plus 45-60 degrees.
- Remove the jack stand.
- Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .