Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition OFF, disconnect the harness connector of the B25B Clutch Pedal Position Sensor.
- Measure the resistance between the signal terminal B and the low reference terminal C (for LHD) or terminal A (for RHD) at the B25B Clutch Pedal Position Sensor. Depress the clutch pedal through the entire range. The resistance should vary from low to high and vice versa without any spikes or dropouts.
- If the resistance is erratic with spikes or dropouts
Replace the B25B Clutch Pedal Position Sensor.
- If the resistance is not erratic without spikes or dropouts
- If the resistance is erratic with spikes or dropouts
- All OK.