Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

If DTC P0642, P0643, P0335, P0336, P0607 or P080A is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
Ignition ON.
Observe the scan tool CPP sensor percent parameter. The percentage should vary from 0% when the clutch pedal is released, to 100% when the clutch pedal is in the apply position.
- If the percentage does not vary
  Refer to Circuit/System Testing .
- If the percentage varies
Perform the CPP learn procedure. Refer to Clutch Pedal Position Sensor Learn .
Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If the DTC resets
  Refer to Circuit/System Testing .
- If the DTC does not reset
All OK.