Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Operate the vehicle on the road at various speeds up to 64 km/h (40 MPH).
Verify with a scan tool that the B14A Transmission Output Shaft Speed Sensor parameter and the speedometer display on the instrument cluster match.
- If the parameter does not match
  Refer to Circuit/System Testing .
- If the parameter matches
Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
- If the DTC resets
  Refer to Circuit/System Testing .
- If the DTC does not reset
All OK.