Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the throttle body (1).
- Install the 4 throttle body bolts (2) and tighten to 8 N.m (71 lb in).
- Connect the throttle body heater inlet pipe (3).
- Connect the throttle body heater outlet pipe (4).
- Connect the positive crankcase ventilation pipe (1).
- Connect the electrical wiring harness connector (2).
- Install the Air Cleaner Assembly. Refer to Air Cleaner Assembly Replacement .
CAUTION:
Refer to Fastener Caution .