LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls/Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Coil Module And Special Tool
    GM2026537Courtesy of GENERAL MOTORS COMPANY
  1. Install the EN-6009  remover/installer (1).
  2. Install the ignition coil (2).
  3. Remove the EN-6009  remover/installer (1).
  4. Install the ignition coil fasteners an tighten to 8 (71 lb in).
    NOTE:

    Note the arrow on the cover.

  5. Install the ignition coil cover in the opposite direction of the arrow.
    6. Fig 2: View Of Engine Wiring Trough And DIS-ignition Module Wiring Harness Plug
    GM1937023Courtesy of GENERAL MOTORS COMPANY
  6. Connect the ignition coil electrical connector (2).
  7. Install the engine wiring harness guide (1) at the cylinder head.
scientia non olet · About LEMON Manuals