LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls/Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission System Hose/Pipe
    GM2496061Courtesy of GENERAL MOTORS COMPANY
  1. Install the evaporative emission pipe.
  2. Connect the evaporative emission pipe (1). Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Evaporative Emission System Hose/Pipe & Retainers
    GM2496064Courtesy of GENERAL MOTORS COMPANY
  3. Connect the evaporative emission pipe (1) to the plastic retainers (2).
    4. Fig 3: Evaporative Emission System Hose/Pipe & Retainer
    GM2496058Courtesy of GENERAL MOTORS COMPANY
  4. Connect the evaporative emission pipe (2) and install the plastic retainer (1).
    5. Fig 4: Evaporative Emission System Hose/Pipe
    GM2676473Courtesy of GENERAL MOTORS COMPANY
  5. Connect the evaporative emission pipe (1). Refer to Plastic Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals