LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls/Fuel - 1.8L (LUW, LWE) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement (Steel Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission Canister & Retaining Tab
    GM2538907Courtesy of GENERAL MOTORS COMPANY
  1. Slide the evaporative emission canister (3) into the evaporative emission canister bracket (2) until the retaining tab (1) snaps into position.
    2. Fig 2: Evaporative Emission Canister Components
    GM2538906Courtesy of GENERAL MOTORS COMPANY
  2. Install the evaporative emission canister (4) into position.
  3. Connect the evaporative emission canister pipes (3). Refer to Plastic Collar Quick Connect Fitting Service 
  4. Connect the evaporative emission canister vent hose (2).
  5. Connect the purge solenoid valve electrical connector (1).
    6. Fig 3: Evaporative Emission Canister Bracket Fasteners
    GM2538905Courtesy of GENERAL MOTORS COMPANY
  6. Install the evaporative emission canister bracket fasteners (1) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals