LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - 6T30/6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Input Speed Sensor Mounting Bolt
    GM1998841Courtesy of GENERAL MOTORS COMPANY
  1. Install the 3 input speed sensor seals (1).
  2. Install the input speed sensor (3).
  3. Verify that the retaining tabs are locked completely.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the input speed sensor bolt (2) M6 x 23 and tighten to 9 (80 lb in).
  5. Install the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
  6. Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn .
scientia non olet · About LEMON Manuals