Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Low and Reverse Clutch Assembly

GM1891390

Courtesy of GENERAL MOTORS COMPANY

Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation

Callout	Component Name
1	Low and Reverse Clutch Assembly (OWC) NOTE: The Low and Reverse Clutch Assembly should rotate freely in one direction and lock in the opposite direction. Align the large flat areas of the Low and Reverse Clutch Assembly with the valve body end of the case.
2	Low and Reverse Clutch Backing Plate
3	Low and Reverse Clutch Plate Assembly (Qty: 3)
4	Low and Reverse Clutch Plate (Qty: 3) NOTE: Align the large flat areas of the Low and Reverse Clutch Plate with the valve body end of the case.
5	Low and Reverse Clutch Apply (Waved) Plate NOTE: Align the large flat areas of the Low and Reverse Clutch Apply Plate with the valve body end of the case. Ensure the correct waved plate is being installed. The 1-2-3-4 clutch and low and reverse clutch waved plates are visually similar, however the low and reverse clutch waved plate is thicker.