Control Valve Body Assembly Assemble (Gen 1)
WARNING: This page is about a different variant/trim than selected.
Control Valve Body Assembly Assemble (Gen 1)
| Callout | Component Name |
|---|---|
| 1 | Valve Body Ball Check Valve (Qty: 6) |
| 2 | Control Valve Channel Plate Spacer Plate Assembly |
| 3 | Valve Channel Plate TIP: Inspect the channel plate bolt pass through holes for damage or brinelling. Any damage could cause leaking. Replace as necessary. |
| 4 | Control Valve Body Bolt M5 x 40.5 (Qty: 1)
CAUTION:
Refer to Fastener Caution . Tighten 7 N.m (62 lb in) |
| 5 | Control Solenoid Valve Support |