LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls/Fuel - 1.8L (LUW, LWE) - DTC P0010 To DTC P0442) >> Diagnostic Information and Procedures >> DTC P0411 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Verify the battery is fully charged before proceeding with this diagnostic procedure. The secondary air injection pump output will vary with system voltage.

  1. Ignition ON
  2. Verify that DTC P0412, P0418, P2430, P2431, P2432, P2433, P2440, or P2444 is not set.
    • If none of the DTCs are set. 
  3. Verify the scan tool BARO pressure parameter is within the range specified in the Altitude Versus Barometric Pressure table.
    • If within the specified range 
  4. Verify the scan tool Secondary Air Injection Pressure Sensor and the BARO pressure parameters are within 3 kPa (0.4 psi).
    • If not within the specified range 

      Replace the Q29 Secondary Air Injection Solenoid Valve

    • If within the specified range 
    5. NOTE:

    Engine coolant temperature must be greater than 5°C (41°F) to enable scan tool device control. It may be necessary to use one of the methods listed below to verify valve operation:

    • Use a stethoscope to listen for valve operation.
    • Disconnect the secondary air injection pipe from the secondary air injection solenoid valve and visually inspect the valve inlet port for valve stem movement.
    • Disconnect the Q29 Secondary Air Injection Solenoid Valve and verify airflow through the valve when commanding the Secondary Air Injection System Active with a scan tool.
  5. Verify the Q29 Secondary Air Injection Solenoid Valve opens and closes when commanding the Secondary Air Injection Solenoid Valve Open and Closed with a scan tool.
    • If the valve opens and closes 
    6. NOTE:

    To prevent the secondary air injection pump from overheating, do not operate the pump consecutively for greater than 2 minutes. The pump is provided with a thermal protector that will automatically reset when allowed to cool.

  6. Verify the G21 Secondary Air Injection Pump turns ON and OFF when commanding the Secondary Air Injection Pump Relay between ON and OFF with a scan tool.
    • If the pump turns ON and OFF 
  7. Engine running
  8. Verify the scan tool Secondary Air Injection Pressure Sensor parameter increases between 14-25 kPa (2.0-3.6 psi) when the Secondary Air Injection Pump Relay is commanded ON with a scan tool.
    • If within the specified range 
  9. Verify the scan tool Secondary Air Injection Pressure Sensor parameter increases between 5-13 kPa (0.7-1.9 psi) when the Secondary Air Injection System is commanded ON with a scan tool.
    • If within the specified range 
  10. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  11. Verify the DTC does not set.
    • If the DTC does not set 
  12. All OK
scientia non olet · About LEMON Manuals