Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0010, P0011, P0013, P0014, P0016, P0017, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0336, P0606, P0651, P0697, P06A3, P0806, P0807, P0808, P1104, P16F3, P182E, P2101, P2122, P2123, P2127, P2128, P2135 or P2138 are not set.
The engine speed is between 500-6,500 RPM or DTC P0315 is set and the engine speed is greater than 1,000 RPM.
The engine coolant temperature (ECT) is between -7 and +125°C (19 and 257°F).
If the ECT is colder than -7°C (+19°F) at start-up, this diagnostic will not run until the ECT is between 21-125°C (70-257°F).
The system voltage is between 9-32 V.
The engine runtime is greater than 2 crankshaft revolutions.
The throttle deltas are less than 95%.
The fuel level is greater than 10%.
The camshaft and crankshaft sensors are synchronized with each other.
DTCs P0300-P0304 run continuously when the above conditions are met.