LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW, LWE)) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Level Indicator Tube And Bolt
    GM2026827Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use a NEW oil level indicator tube seal

  1. Install the oil level indicator tube (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the oil level indicator tube bolt (1) and tighten to 15 N.m (11 lb ft).
  3. Check the oil level and adjust as necessary.
scientia non olet · About LEMON Manuals