Crankshaft End Play, Check
WARNING: This page is about a different variant/trim than selected.
- Install the GE-571-B
gauge (1).
- Install in the holder on the front of the engine block.
- Place the dial gauge plunger against the crankshaft and adjust.
- Measure the longitudinal play of the crankshaft.
- Move the crankshaft in the longitudinal direction.
- Permissible crankshaft end play: 0.100-0.202 mm (0.0039-0.0080 in)
- Remove the GE-571-B gauge.
NOTE:
Crankshaft attached with crankshaft bearing caps.