Reaction Carrier Shaft Replacement

Reaction Carrier Shaft Replacement

Removal Procedure

Tools Required

* J 8092 - Universal Driver Handle - 3/4 in - 10

* J 7004-A - Universal Remover

* J 23907 - Slide Hammer with Bearing Adapter

* J 25019-14 - Stator Pump Bushing Remover

* J 29369-2 - Bushing and Bearing Remover 2-3 in

* J 34196-B - Transmission Bushing Service Set





1. Remove the reaction carrier shaft/internal gear retainer (668) and the reaction carrier shaft (666) from the input internal gear (664).

2. Inspect the reaction carrier shaft (666) and the input internal gear (664) for the following defects:

* Scoring

* Cracking

* Damaged or worn bushings

* A cracked shaft

* A damaged spline

* Damaged gear teeth





3. Using J 29369-2 - bushing and bearing remover 2-3 in with J 23907 - slide hammer with bearing adapter, remove the reaction carrier shaft front bushing (665).





4. Using J 25019-14 - stator pump bushing remover with J 7004-A - universal remover, remove the reaction carrier shaft rear bushing (667).

Installation Procedure





1. Using J 34196-3 which is part of kit J 34196-B - transmission bushing service set with J 8092 - universal driver handle - 3/4 in - 10, install a new reaction carrier shaft front bushing (665).





2. Using J 34196-3 which is part of kit J 34196-B - transmission bushing service set with J 8092 - universal driver handle - 3/4 in - 10, install a reaction carrier shaft rear bushing (667).