Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab New Motor)

Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab New Motor)

Perform the Initialization/Teach Procedure any time a new sunroof motor/actuator is installed in the vehicle.





1. Press and hold the open switch until the glass panel stalls at the hard stop, then moves slightly forward. This position is called the soft stop or full open position.

2. Release the switch.

3. Press and hold the open switch within 6 seconds.

4. Hold the open switch until the glass panel moves to the closed position and stops.

5. Release the switch.