Sunroof Opening Trim Finish Lace Replacement (Extended Cab)

Sunroof Opening Trim Finish Lace Replacement (Extended Cab)

Removal Procedure





1. Beginning at the joint located in the center rear of the lace of the sunroof opening, pull the sunroof finishing lace from the sunroof window track assembly.

2. Remove the sunroof finishing lace from the track.

Installation Procedure





1. Position the end of the sunroof finishing lace at the center rear of the sunroof opening.





2. Push the finishing lace (2) onto the track assembly flange (1) until fully seated around the sunroof opening.

3. Pull the finishing lace draw cord toward the sunroof opening. Remove the cord from the periphery of the opening.

4. Ensure that the finishing lace (2) is properly seated over the outer surface of the headliner (3).