Rear Suspension

Stabilizer Shaft Insulator Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the bolt from the stabilizer shaft insulator bracket (3).

3. Remove the stabilizer shaft insulator bracket.

4. Remove the stabilizer shaft insulator (2) from the stabilizer shaft.

Installation Procedure





1. Install the stabilizer shaft insulator (2) to the stabilizer shaft.

2. Install the stabilizer shaft insulator bracket (3).

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the stabilizer shaft bracket nuts.

Tighten the bolts to 48 Nm (35 lb ft).

4. Lower the vehicle.