LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - On Vehicle (2 Of 2)) >> Oil Pump Suction Pipe and Screen Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    2. Fig 2: View Of Oil Suction Pipe
    GM1210965Courtesy of GENERAL MOTORS CORP.
  2. Install the oil suction pipe.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil suction pipe bolts and tighten to 10 N.m (89 lb in).
    4. Fig 3: View Of Oil Pan Scraper And Bolts
    GM1210963Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts and tighten to 10 N.m (89 lb in).
  6. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals