LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - On Vehicle (2 Of 2)) >> Cylinder Head Replacement - Right Side (LF1) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right bank secondary timing chain. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Right Side .
  2. Remove the power brake booster pump aside.
  3. Remove the catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LF1) .
    4. Fig 1: View Of Right Cylinder Head & Bolts
    GM2202033Courtesy of GENERAL MOTORS CORP.
  4. Remove the right cylinder head bolts (1).
  5. Remove the right cylinder head (2).
  6. Remove Ground wire and harness and position aside.
    7. Fig 2: View Of Right Cylinder Head Gasket
    GM2202034Courtesy of GENERAL MOTORS CORP.
  7. Remove and discard the cylinder head gasket (1).
  8. Clean and inspect the cylinder head and the engine block sealing surfaces. Refer to Cylinder Head Cleaning and Inspection and Engine Block Cleaning and Inspection .
  9. Disassemble the cylinder head if needed. Refer to Cylinder Head Disassemble (LF1 or LFW) .
  10. Transfer parts as needed.
scientia non olet · About LEMON Manuals