Auxiliary Water Pump Inlet Hose Replacement (LAU)

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Auxiliary Water Pump Inlet Hose (LAU)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill LF1) or Cooling System Draining and Filling - Vac-N-Fill (GE 47716) or Cooling System Draining and Filling (Static Fill LAU) Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
1	Auxiliary Water Pump Inlet Hose Clamps (Qty 2) Procedure: Disengage tension on the auxiliary water pump inlet hose clamps using BO-38185: Hose Clamp Pliers. Special Tools: BO-38185: Hose Clamp Pliers For equivalent regional tools, Refer to Special Tools
2	Auxiliary Water Pump Inlet Hose

Callout

Component Name

Preliminary Procedures

Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill LF1) or Cooling System Draining and Filling - Vac-N-Fill (GE 47716) or Cooling System Draining and Filling (Static Fill LAU)
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle

Auxiliary Water Pump Inlet Hose Clamps (Qty 2)
Procedure:
Disengage tension on the auxiliary water pump inlet hose clamps using BO-38185: Hose Clamp Pliers.
Special Tools:
BO-38185: Hose Clamp Pliers
For equivalent regional tools, Refer to Special Tools

Auxiliary Water Pump Inlet Hose