Rear Output Shaft Seal Replacement

Rear Output Shaft Seal Replacement

Special Tools

J 45756 - Rear Output Shaft Seal Installer

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

Caution: Refer to Transfer Case Seal Removal Caution Service Precautions.




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement One-Piece Propeller Shaft Replacement.

3. Remove the rear output shaft seal by prying it out with a flat tipped tool.

Installation Procedure




1. Using J 45756 - installer , install a new rear output shaft seal.

2. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement One-Piece Propeller Shaft Replacement.

3. Check the fluid level. Add fluid, if necessary.

4. Lower the vehicle.