LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Engine Mechanical - 1.8L (2H0 Or LUW) - Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch off the engine.
  2. Remove the EN-232:  adapter.
  3. Remove the EN-498-B:  gauge.
  4. Install new closure bolt in the cylinder head.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the closure bolt to 15 N.m (11 lb ft).
  6. Check the engine oil level.
scientia non olet · About LEMON Manuals