Fastener Tightening Specifications (On Vehicle)
WARNING: This page is about a different variant/trim than selected.
Fastener Tightening Specifications (On Vehicle)
| Application | Ref No. | Quantity | Size | Specification | |
|---|---|---|---|---|---|
| Metric | English | ||||
| Case Extension Stud to Case Extension | 17 | 2 | M10x1.5 | 15 N.m | 11 lb ft |
| Case Extension to Case Assembly | 16 | 6 | M10x1.5x40 | 55 N.m | 41 lb ft |
| Control Solenoid Valve Assembly and Control Valve Lower Body Assembly to Control Valve Upper Body Assembly | 310 | 6 | M5x0.8x55 | 8 N.m | 71 lb in |
| Control Solenoid Valve Assembly and Control Valve Lower Body Assembly to Control Valve Upper Body Assembly | 309 | 10 | M5x0.8x45 | 8 N.m | 71 lb in |
| Control Solenoid Valve Heat Sink to Valve Body | 312 | 2 | M5x0.8x53 | 8 N.m | 71 lb in |
| Control Valve Upper Body Assembly to Control Valve Lower Body Assembly | 301 | 12 | M5x0.8x36 | 8 N.m | 71 lb in |
| Control (with Body and Valve) Valve Assembly to Case Assembly | 22 | 6 | M5x0.8x73 | 8 N.m | 71 lb in |
| Driveline support Assembly Front Plug Bolts | - | - | - | 50 N.m | 37 lb ft |
| Flexplate to Torque Converter Bolts | - | - | - | 63 N.m | 47 lb ft |
| Fluid Pan Assembly to Case Assembly | 30 | 18 | M6x1.0x20 | 9 N.m | 80 lb in |
| Trans Oil Level Check Plug to Fluid Pan Assembly | 31 | 1 | M12x1.75 | 25 N.m | 18 lb ft |
| Fluid Pump Cover Assembly to Torque Converter Housing | 231 | 13 | M6 1.0x40 | 11 N.m | 97 lb in |
| Input and Output Speed Sensor Assembly to Control Valve Upper Body Assembly | 302 | 2 | M6x1.0x20 | 12 N.m | 106 lb in |
| Line Pressure Test Hole Plug to Torque Converter Housing | 202 | 1 | 1/8-27 NPTF | 11 N.m | 97 lb in |
| Manual Shaft Detent Assembly to Valve Body | 23 | 1 | M6x1.0x14.5 | 12 N.m | 106 lb in |
| Propeller Shaft Hub Clamp Bolt | - | - | - | 130 N.m | 96 lb ft |
| Rear Suspension Crossmember Mounting Nuts | - | - | - | 110 N.m | 81 lb ft |
| Rear Shock Absorber Lower Mounting Bolt | - | - | - | 220 N.m | 162 lb ft |
| Transaxle Mount to Differential Nuts | - | - | - | 50 N.m | 37 lb ft |
| Transmission Shift Cable Bracket Retaining Nuts | - | - | - | 20 N.m | 15 lb ft |
| Torque Converter Housing Assembly to Case Assembly | 3 | 9 | M10x1.5x50 | 72 N.m | 53 lb ft |
| *Reference number refers to the component callout number in Disassembled Views | |||||