LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 6L80 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Transmission Overheats

Transmission Overheats

WARNING: This page is about a different variant/trim than selected.
Checks Causes
Transmission Fluid Level
  • Inspect for incorrect (low) transmission fluid level.
  • Inspect transmission for leaks.
Transmission Fluid Cooler and Cooler Lines
  • Inspect for obstructed air flow to transmission fluid cooler.
  • Inspect for restricted transmission fluid cooler and/or cooler lines.
  • Clean or replace transmission fluid cooler and/or cooler lines if necessary.
  • If fluid cooler and/or cooler lines are okay, replace the Cooler Bypass Valve or Fluid Cooling Exchanger (model specific).
Engine Overheating Refer to ENGINE OVERHEATING .
Torque Converter
  • Converter may be stuck OFF. Inspect torque converter circuit for debris or obstruction. Refer to Torque Converter Diagnosis .
  • Replace torque converter if necessary.
Automatic Transmission Fluid Temperature Sensor Inspect for transmission fluid temperature sensor related DTC's due to inaccurate or faulty sensor.
Trailer Towing or Hauling Ask customer about driving habits while towing. Improper trailer towing or vehicle load limits may have been exceeded. Towing should occur in Tow/Haul Mode.