LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission - 6L80 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> No Reverse Gear

No Reverse Gear

WARNING: This page is about a different variant/trim than selected.
No Reverse Gear

Checks Causes
A//Trans Fluid Pan Assembly (29) Verify proper fluid level and condition, inspect transmission assembly for leaks.
Control Valve Upper Body (304)
  • Inspect for sticking, damaged, or worn 3-5-R regulator valve (336) and valve spring (326).
  • Inspect for damaged or missing #5 ball check valve.
Control Valve Lower Body (307) Inspect for worn, damaged, or sticking clutch select solenoid valve 3 (352) and valve spring (353).
1-2-3-4 and 3-5-R Clutch (51)
  • Inspect for proper installation of 3-5-R clutch backing plate retaining ring (400).
  • Inspect for worn, damaged, or leaking clutch bearing seal assembly (428).
  • Inspect for damaged or worn 3-5-R clutch plates (401-404).
  • Inspect for damaged 3-5-R clutch piston (421), apply ring (405), and spring (420).
  • Inspect for cut, worn, or damaged 3-5-R clutch piston dam O-ring seal (418), inner seal (419), and outer seal (422).
  • Inspect for improper selective 3-5-R clutch backing plate retaining ring (400).
Torque Converter Housing (2)
  • Inspect for worn or damaged 1-2-3-4 and 3-5-R clutch fluid seal rings (230).
  • Inspect for damaged or scored pump housing (203), cover (219), rotor (217), slide (212), and vanes (216).
  • Inspect for damaged or porous pump cover assembly (219). Inspect pump surfaces for flatness.
  • Inspect for excessive fluid pump rotor (217) clearance or damage. Ensure proper selective rotor is being utilized.
Center Support Fluid Passage Seal Assembly (20)

A/Trans Fluid Pump Seal Assemblies (18 and 19)
  • Inspect for worn, cut, or damaged seals.
  • Inspect for proper seal (20) size (6L45/50E MYA/MYB) vs (6L80/90E MYC/MYD).
Center Support (67)
  • Inspect for damaged or leaking low and reverse clutch piston assembly (470).
  • Inspect for damaged or worn low and reverse clutch plates (462-465).
  • Inspect for damaged low clutch sprag assembly (467). Holding the sprag assembly with the retaining ring facing up, and the inner race of the sprag assembly fixed, the outer race should freewheel counterclockwise.
2-6 and 3-5-R Clutch Hub (64) Inspect for damaged or distorted shaft on hub assembly.
Output Shaft Assembly (70) Inspect for damaged or stripped splines on the output shaft.
scientia non olet · About LEMON Manuals