Supercharger Air Inlet Pressure Sensor Replacement (LS9)
Supercharger Air Inlet Pressure Sensor Replacement (LS9)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the upper intake cover. Refer to Upper Intake Manifold Sight Shield Replacement (LS9) , Upper Intake Manifold Sight Shield Replacement (w/o LS9) . |
|
| 1 | Super Charger Air Pressure Sensor Bolt
CAUTION:
Refer to Fastener Caution . Tighten 10 N.m (89 lb in) |
| 2 | Super Charger Air Inlet Pressure Sensor TIP: Always install the NEW O-ring provided with the super charger pressure sensor. Procedure Disconnect the super charger pressure sensor harness connector. |