Hood Replacement
Hood Replacement
| Callout | Component Name |
|---|---|
| 1 | Hood Open Assist Rod (Qty: 2)
WARNING:
When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
CAUTION:
Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result. Procedure Use a small flat-bladed tool to release the metal clips at the ends of the assist rod, then pull away from the stud. |
| 2 | Hood Hinge Bolt (Qty: 4)
CAUTION:
Refer to Fastener Caution . Tighten 24 N.m (18 lb ft) |
| 3 | Hood |