Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Cushion Outer Trim Panel (Manual Seat Without HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Recliner Lever Procedure Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.
2	Front Seat Manual Lumbar Knob Procedure Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
3	Front Seat Adjuster Outer Finish Cover CAUTION: Refer to Fastener Caution . Procedure Remove the screw from front of the cover. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover. Pull outward to release the retainers from the seat assembly. Disconnect the electrical connectors. Tighten 2 N.m (18 lb in)

Callout

Component Name

Front Seat Recliner Lever
Procedure
Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.

Front Seat Manual Lumbar Knob
Procedure
Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.

Front Seat Adjuster Outer Finish Cover

CAUTION:

Refer to Fastener Caution .

Procedure

Remove the screw from front of the cover.
Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
Pull outward to release the retainers from the seat assembly.
Disconnect the electrical connectors.

Tighten
2 N.m (18 lb in)