Windshield Pillar Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Pillar Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the front assist handle, passenger side only. Refer to Front Assist Handle Replacement .
1	Windshield Side Garnish Molding Cover
2	Windshield Side Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Windshield Side Garnish Molding Assembly Procedure Tabs must be installed prior to retainers. Tabs to be fully seated in I/P trim panel retainer and valance panel. Disconnect electrical connectors.
4	Windshield Side Garnish Molding Retainer (Qty: 2)